Marantz SR5013 Owners Manual English - Page 231
Dolby Atmos, Dolby TrueHD, DTS-HD, Dolby Digital Plus audio is not output.
View all Marantz SR5013 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 231 highlights
Contents Connections Playback Settings Tips Appendix DTS sound is not output. 0 Check that the digital audio output setting on the connected device is set to "DTS". Dolby Atmos, Dolby TrueHD, DTS-HD, Dolby Digital Plus audio is not output. 0 Make HDMI connections. (v p. 57) 0 Check the digital audio output setting on the connected device. On some devices, "PCM" is set by default. DTS Neural:X mode cannot be selected. 0 DTS Neural:X cannot be selected when using the headphones. Dolby Surround mode cannot be selected. 0 Dolby Surround cannot be selected when using the headphones. Audyssey MultEQ® XT, Audyssey Dynamic EQ® and Audyssey Dynamic Volume® cannot be selected. 0 These cannot be selected when you have not performed Audyssey® Setup. (v p. 179) 0 Switch to a sound mode other than "Direct" or "Pure Direct". (v p. 118) 0 These cannot be selected when sound mode is "DTS Virtual:X" or sound mode that have "+Virtual:X" in the sound mode name. 0 These cannot be selected when using the headphones. "M-DAX" cannot be selected. 0 Check that an analog signal or PCM signal (Sample Rate = 44.1/48 kHz) is input. For playback of multichannel signals such as Dolby Digital or DTS surround, "M-DAX" cannot be used. (v p. 154) 0 Switch to a sound mode other than "Direct" or "Pure Direct". (v p. 118) No sound is output when using ZONE2. 0 Digital signal audio input from the HDMI connector or digital audio connectors (OPTICAL/COAXIAL) cannot be played back. Use analog connections. 0 When listening to audio from a Bluetooth device in ZONE2, remove any obstructions between the Bluetooth device and this unit and use it within a range of about 98.4 ft/30 m. Front panel Display Rear panel 231 Remote Index