Marantz SA-KI Ruby Owners Manual English - Page 22

ENGLISH n Audio device settings (Mac OS only) A With the unit power off, connect the unit and Mac using a USB cable (sold separately). 0 For the connection procedure, refer to the "Connecting a PC or Mac" section. (v p. 9) B Press the main unit's X. C Press DISC/INPUT to switch the playback media mode to "USB-DAC". D Move the cursor to "Go" on the computer screen, and then click "Utilities". 0 The utility list is displayed. E Double-click "Audio MIDI Setup". 0 The "Audio Devices" window is displayed. F Check that "Use this device for sound output" is checked in "SA-KI RUBY". 0 If a different device is checked, select and "Secondary click" on "SA-KI RUBY", and then select "Use this device for sound output". G Select the "SA-KI RUBY" format. 0 It is normally recommended to set the format to "384000.0 Hz" and "2ch-32 bit Interger". . SA-KI RUBY SA-KI RUBY ᶉ SA-KI RUBY ᶈ SA-KI RUBY H Quit Audio MIDI Setup. n Playback Install the desired player software on your computer beforehand. Use the rear panel USB-DAC port to connect this unit to a computer. (v p. 9) 1 Press DISC/INPUT to switch the playback media mode to "USB-DAC". Start playback on the computer's player software. The digital audio signal that is being input is shown as follows in the display. 0 When a linear PCM signal is input GExampleH PCM176.4k/24 0 Files are displayed in order of sampling frequency and bit length. 0 The displayed bit length is the bit count at the time the audio signal is input from the computer to the D/A converter of this unit. 0 When a DSD signal is input GExampleH DSD 11.2M 0 Only the sampling frequency is displayed when a DSD signal is input. 0 If the sampling frequency cannot be detected, "Unlock" will be displayed. 0 "Unsupported" is displayed when audio signals that are not supported by this unit are input. . 21