Marantz AV7705 Owners Manual English - Page 304

Contents Connections Playback Settings Tips z1 During playback in Pure Direct mode, the surround parameters are the same as in Direct mode. z2 This item can be selected when a Dolby Digital, Dolby Digital Plus, Dolby TrueHD or Dolby Atmos signal is played. z3 This item can be selected when a Dolby Digital, Dolby Digital Plus, Dolby TrueHD, Dolby Atmos, DTS:X or DTS signal is played. z4 This item can be selected when a DTS:X signal that is compatible with the Dialog Control function is input. z5 This item can be selected when a Dolby Digital or DTS signal or DVD-Audio is played. z6 This item can be selected when Height, Ceiling or Dolby Atmos Enabled speakers are used. z7 This setting is available when "Subwoofer Mode" in the menu is set to "LFE+Main". (v p. 232) z8 This item can be set when "Front" is set to "Small" or "Subwoofer Mode" is set to "LFE+Main". (v p. 223, 232) z9 This can be set if the input signal does not contain an Auro-3D signal or if the input Auro-3D signal does not contain Front Height channels. z10 This item cannot be set when "Dynamic EQ" is set to "On". (v p. 182) z11 This item cannot be set when "Center" is set to "None". (v p. 224) z12 This item cannot be set when "Subwoofer" in the menu is set to "None". (v p. 224) z13 This item cannot be set when Audyssey® Setup (Speaker Calibration) has not been performed. z14 This item cannot be selected when a DTS:X format with a sampling frequency of over 48 kHz is input. z15 This item cannot be set when "MultEQ® XT32" in the menu is set to "Off". (v p. 181) z16 This item cannot be set when sound mode is "DTS Virtual:X" or sound mode that have "+Virtual:X" in the sound mode name. z17 This item can be set when the input signal is analog, PCM 48 kHz or 44.1 kHz. z18 This can be set when the LFE signal is included in the input signal. Appendix Front panel Display Rear panel 304 Remote Index