Makita XT610 DML185 Instruction Manual - Page 5

• To insert the battery cartridge, align the tongue on the battery cartridge with the groove in the housing and slip it into place. Always insert it all the way until it locks in place with a little click. If you can see the red part on the upper side of the button, it is not locked completely. Insert it fully until the red part cannot be seen. If not, it may accidentally fall out of the tool, causing injury to you or someone around you. • Do not use force when inserting the battery cartridge. If the cartridge does not slide in easily, it is not being inserted correctly. Lighting up the bulb (Fig. 2) CAUTION: • Do not look in the light or see the source of light directly. • This tool has function that bulb light goes out at low voltage. At this time, recharge the battery cartridge. Push the switch to light up the bulb. To turn off, push the switch again. The following tables indicate the operating time on a single charge. Model Voltage DML145 14.4V DML185 18V Battery cartridge BL1415 BL1415N BL1430 BL1440 BL1815 BL1815N BL1820 BL1830 BL1840 Operating time Approx. 100 min Approx. 130 min Approx. 220 min Approx. 340 min Approx. 110 min Approx. 130 min Approx. 180 min Approx. 240 min Approx. 340 min Head angle (Fig. 2) The head angle can be adjusted in four stages. Adjust as desired. ASSEMBLY Replacing bulb (Fig. 3 & 4) CAUTION: The bulb is very hot immediately after operation. Wait until the bulb cools off before attempting to replace it. First, turn the ring counterclockwise and remove the reflector. Then replace the bulb. Shoulder strap (Fig. 5) Install the strap on the tool. MAINTENANCE To maintain product safety and reliability, repairs, maintenance or adjustment should be carried out by a Makita Authorized Service Center. ACCESSORIES CAUTION: These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of any other accessories or attachments might present a risk of injury to persons. The accessories or attachments should be used only in the proper and intended manner. • Bulb set (2 pcs.) • Shoulder strap • Various type of Makita genuine batteries and chargers 5