Linksys WRT160N Firmware Upgrade - Page 14

VALET, Internet Explorer, Safari, IP Address, Enter], User name, Password, IMPORTANT, Valet Settings - can not access advanced settings

Get Linksys WRT160N - Wireless-N Broadband Router Wireless PDF manuals and user guides
UPC - 745883582983
View all Linksys WRT160N manuals
Add to My Manuals
Save this manual to your list of manuals

Page 14 highlights

VALET Checking the firmware version of your router Step 1: Access the Hotspot's web-based setup page. To do this, launch a web browser such as Internet Explorer or Safari. Enter your hotspot's IP Address on the address bar, then press [Enter]. Once the login prompt appears, enter your router's User name and Password. NOTE: The default IP Address of Linksys routers is "192.168.1.1". To view instructions on how to check the IP address of your router, click here. IMPORTANT: The default User name and Password is "admin" but if you have used Cisco Connect to set up your router, you may have to open the software to retrieve them. To retrieve your router User name and Password through Cisco Connect, go to Valet Settings > Advanced Settings. Step 2: Once you have the setup page open, check the upper right corner of the screen for the firmware version.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
VALET
Checking the firmware version of your router
Step 1:
Access the
Hotspot’s
web-based setup page.
To do this,
launch a web browser such as
Internet Explorer
or
Safari
. Enter your
hotspot’s
IP Address
on the address bar, then press
[Enter]
.
Once the login prompt
appears, enter your router’s
User name
and
Password
.
NOTE:
The de
fault IP Address of Linksys routers is “192.168.1.1”.
To view instructions on how to check the
IP address of your router, click
here
.
IMPORTANT:
The default User name and
Password is “admin” but if you have used Cisco Connect to set
up your router, you may have to open the software to retrieve them. To retrieve your router User name and
Password through Cisco Connect, go to
Valet Settings > Advanced Settings
.
Step 2:
Once you have the setup page open, check the upper right corner of the screen for the firmware version.