LiftMaster RSL12UL UPDATED Gate Safety Checklist - Page 1

Swing and Slide Gate Operator UL 325 and ASTM F2200 Site Planning Safety Checklist Please Print Name: Address: City/State/ZIP: Phone: Email: Satisfactory Needs Repair/Replacement Gate Safety Check - Simple steps to quickly determine if an End User's gate operator is safe. UL 325 Standard Component: Result (Circle) Comments: Figures (On Back) 1. Gate Operator is approved to current UL 325 standards (check operator label) Pass / Fail 2. Proper gate warning signs attached to both sides of gate area Pass / Fail 1,4 3. All entrapment zones protected by 2 safety devices/obstruction tested 1,4 Close Side (circle two) Photo Eye Reversing Edge Inherent Reverse Pass / Fail Open Side (circle two) Photo Eye Reversing Edge Inherent Reverse Pass / Fail Other Entrapment Areas Pass / Fail *Entrapment Zone: The location where an object can be caught or held in a position that increases the risk of injury ASTM F2200 Standards Gate Construction Evaluation: Gate Constructed with Safety in mind. ASTM F2200 Standards are followed Component: Result (Circle) All Gates Gates have smooth bottom edges, no protrusions exceed 1/2" beyond base of gate Pass / Fail All access controls at least 6 ft. from gate Pass / Fail Barbed tape (razor wire) at least 8 ft. above grade Pass / Fail Barbed wire at least 6 ft. above grade Pass / Fail Separate pedestrian gate - out of reach of a moving gate - vehicular gate is for automotive traffic only Pass / Fail Gate does not move on its own if disconnected from operator Pass / Fail Gates prevented from falling over if disconnected from supporting hardware Pass / Fail SWING Distance from pivot point to column edge is less than 4 in. Pass / Fail Distance from open gate to wall or column greater than 16 in. or external entrapment protection is provided Pass / Fail SLIDE Roller covers on wheels Pass / Fail Meshing installed up to 6 ft. above grade if pickets spaced equal to or greater than 2 1/4 in. apart Pass / Fail Gap between gate and fence post less than 2 1/4 in. & gap protected with safety device Pass / Fail Positive stops at both fully open and fully closed positions Pass / Fail Receiver guides recessed behind receiver post for receiver guides less than 8 ft. Pass / Fail Other: Pass / Fail Comments: Figures (On Back) 5 1,4 1,4 4 4 1 3 2 1 Please Print First & Last Name of Dealer: Name of Dealership: Dealership Address (Street Address/City/State/Zip): Dealer Signature: Customer Signature: First & Last Name of Installer: Phone: Installer Signature: © 2018 LiftMaster All Rights Reserved 300 Windsor Drive, Oak Brook, IL 60523 LMSPCLSWSL 4/18