LiftMaster MEGA SWING MEGA SWING - MSWDCBB Manual - Page 2

Table Of Contents, Introduction - gate parts

Get LiftMaster MEGA SWING PDF manuals and user guides View all LiftMaster MEGA SWING manuals
Add to My Manuals
Save this manual to your list of manuals

Page 2 highlights

TABLE OF CONTENTS INTRODUCTION INTRODUCTION REPAIR PARTS 20 Carton Inventory 3 Manual Release 3 ACCESSORIES 21 UL325 Model Classifications 4 Safety Installation Information 5 SAFETY ACCESSORIES FOR SECONDARY Safety Precautions for Swing and Ornamental ENTRAPMENT PROTECTION 21 "Grill Type Gates 6 Warning Sign Placement 6 WARRANTY 22 Recommended Photo Cell Layout REPAIR PARTS AND SERVICE 23 for Secondary Entrapment Protection 7 Operator Overview 8 INSTALLATION CHECK OFF LIST 24 INSTALLATION Concrete Pad 9 Anchors 9 Conduits 9 Safety Edge Installation 9 Drive Arm Adjustments 9 WIRING AND HOOKUP AC Power Hookup (120/230 Vac 10 Input Commands Connections 11 Accessory Connections 12 Battery Installation 12 Master/Second Wiring 12 TIMERS AND MODE SELECTIONS S1 & S2 Fast Run Timer - Switch Pack S1 (1-5 13 Mode Selections - Switch Pack S1 (6-8 13 Close Timer - Switch Pack S2 (1-5 13 Mode Selections - Switch Pack S2 (6-8 13 ADJUSTMENTS Right or Left Hand Operation 14 Limit Switch Adjustments 14 Instant Reverse Device (IRD 14 IMPORTANT NOTES • BEFORE attempting to install, operate or maintain the operator, you MUST read and fully understand this manual and follow all safety instructions. • DO NOT attempt repair or service of your commercial door and gate operator unless you are an Authorized Service Technician. INSTALL THE RECEIVER Set Security Mode 15 Programming the Remote to the Receiver 15 To Erase All Remote Control Codes 15 WARNING MAINTENANCE General Service 16 Battery Disposal 16 Battery Replacement 16 CAUTION Battery Maintenance/Testing 16 Battery Handling/Storage 16 TROUBLESHOOTING Battery Checkout 17 Gate Not Operating 17 SUGGESTED LOOP SENSOR LOCATIONS Free Exit on Vehicle Approach 18 Entry With Access Control Device 18 Dual Direction as Entry and Free Exit 18 CONTROL BOARD LAYOUT Component Locations 19 WARNING CAMUechTaInOicaNl WARNING WWEleAActRrRicNaNl ININGG CAUTION When you see these Safety Symbols and Signal Words on the following pages, they will alert you to the possibility of SERIOUS INJURY or DEATH if you do not comply with the warnings that accompany them. The hazard may come from something mechanical or from electric shock. Read the warnings carefully. AVERTISSEMENT When you see this Signal Word on the following pages, it will alert you to the possibility of damage to your gate and/or the gate operator if you do not comply with the cautionary statements that accompany it. ReadAthTemTcaErefNullyT. ION AVERTISSEMENT AVERTISSEMENT 2 AVERTISSEMENT

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
2
INTRODUCTION
Carton Inventory. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3
Manual Release
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3
UL325 Model Classifications . . . . . . . . . . . . . . . . . . . . . . . . . .4
Safety Installation Information . . . . . . . . . . . . . . . . . . . . . . . . . 5
Safety Precautions for Swing and Ornamental
“Grill Type Gates”. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .6
Warning Sign Placement . . . . . . . . . . . . . . . . . . . . . . . . . . . . .6
Recommended Photo Cell Layout
for Secondary Entrapment Protection
. . . . . . . . . . . . . . . . . . .7
Operator Overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .8
INSTALLATION
Concrete Pad . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .9
Anchors . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .9
Conduits. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .9
Safety Edge Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .9
Drive Arm Adjustments
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .9
WIRING AND HOOKUP
AC Power Hookup (120/230 Vac)
. . . . . . . . . . . . . . . . . . . . .10
Input Commands Connections. . . . . . . . . . . . . . . . . . . . . . . .11
Accessory Connections
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .12
Battery Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12
Master/Second Wiring . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .12
TIMERS AND MODE SELECTIONS S1 & S2
Fast Run Timer - Switch Pack S1 (1-5) . . . . . . . . . . . . . . . . .13
Mode Selections - Switch Pack S1 (6-8) . . . . . . . . . . . . . . . .13
Close Timer - Switch Pack S2 (1-5). . . . . . . . . . . . . . . . . . . .13
Mode Selections - Switch Pack S2 (6-8) . . . . . . . . . . . . . . . .13
ADJUSTMENTS
Right or Left Hand Operation . . . . . . . . . . . . . . . . . . . . . . . . . 14
Limit Switch Adjustments
. . . . . . . . . . . . . . . . . . . . . . . . . . .14
Instant Reverse Device (IRD). . . . . . . . . . . . . . . . . . . . . . . . .14
INSTALL THE RECEIVER
Set Security Mode . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .15
Programming the Remote to the Receiver. . . . . . . . . . . . . . .15
To Erase All Remote Control Codes . . . . . . . . . . . . . . . . . . . . 15
MAINTENANCE
General Service
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .16
Battery Disposal . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 16
Battery Replacement
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .16
Battery Maintenance/Testing
. . . . . . . . . . . . . . . . . . . . . . . . .16
Battery Handling/Storage . . . . . . . . . . . . . . . . . . . . . . . . . . . . 16
TROUBLESHOOTING
Battery Checkout
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .17
Gate Not Operating. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .17
SUGGESTED LOOP SENSOR LOCATIONS
Free Exit on Vehicle Approach . . . . . . . . . . . . . . . . . . . . . . . .18
Entry With Access Control Device
. . . . . . . . . . . . . . . . . . . . .18
Dual Direction as Entry and Free Exit. . . . . . . . . . . . . . . . . . .18
CONTROL BOARD LAYOUT
Component Locations
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .19
TABLE OF CONTENTS
IMPORTANT NOTES
•
BEFORE attempting to install, operate or maintain the operator,
you MUST read and fully understand this manual and follow all
safety instructions.
•
DO NOT attempt repair or service of your commercial door and
gate operator unless you are an Authorized Service Technician.
INTRODUCTION
Mechanical
Electrical
WARNING
WARNING
WARNING
WARNING
CAUTION
CAUTION
When you see these Safety Symbols and Signal Words on the
following pages, they will alert you to the possibility of
SERIOUS
INJURY
or
DEATH
if you do not comply with the warnings that
accompany them. The hazard may come from something
mechanical or from electric shock. Read the warnings carefully.
When you see this Signal Word on the following pages, it will
alert you to the possibility of damage to your gate and/or the gate
operator if you do not comply with the cautionary statements that
accompany it. Read them carefully.
REPAIR PARTS
20
ACCESSORIES
21
SAFETY ACCESSORIES FOR SECONDARY
ENTRAPMENT PROTECTION
21
WARRANTY
22
REPAIR PARTS AND SERVICE
23
INSTALLATION CHECK OFF LIST
24