LiftMaster KPW5 KPW5 Manual - Page 2

INSTALLATION To prevent possible SERIOUS INJURY or DEATH from a moving gate or door: • ALWAYS keep remote controls out of reach of children. NEVER permit children to operate or play with remote controls. • Activate gate or door ONLY when it can be seen clearly, is properly adjusted, and there are no obstructions to door travel. • ALWAYS keep gate or door in sight until completely closed. NEVER permit anyone to cross path of moving gate or door. 1. Choose a mounting location suitable for your application such as a wall, flat surface, or a pedestal with a 3" x 3" mounting pattern (LiftMaster gooseneck pedestal post models PED42 or PED64). Battery Cover Faceplate 2. Unlock and remove the faceplate from the mounting plate. 3. Mount the mounting plate to the desired surface and secure with 1/4" screws or bolts (not provided). Mounting plate 4. Remove the battery cover using a Phillips screw driver. Install the battery (provided) and re-install inner cover. Battery 5. Reattach the faceplate to the mounting plate and lock with the key. BASIC PROGRAMMING The Wireless Commercial Keypad must be put into programming mode prior to any of the programming steps below unless otherwise indicated. The keypad backlight will remain on if the product is in programming mode. While in programming mode, if an invalid code is entered, an error tone will sound, but the keypad will remain in programming mode. After 60 seconds of inactivity, the keypad will exit the programming mode. The 6-digit Master Code is used to prevent unauthorized access to the system. A Master Code is required (factory default code: 888888) to operate the Wireless Commercial Keypad. It is highly recommended to change and record your unique Master Code. Set Master Code Programming Step 1. Enter program mode 2. Update Master Code 3. Exit Program Mode Program a PIN Keystroke Combination * (Master Code) # 09 # (New 6-digit Code) # (New 6-digit Code) # * * # Indicator Long tone Long tone Keypad backlight will turn off Programming Step Keystroke Combination Indicator * 1. Enter program mode (Master Code) # Long tone 2. Set new pin 01 # (New 4-digit PIN) # (new 4-digit PIN) # Long tone * * 3. Exit Program Mode # Keypad backlight will turn off NOTE: An error tone will sound if the maximum number of PINs is exceeded or if user tries to program a PIN already programmed in the memory. 2