LiftMaster EL1SS EL1SS Installation and Programming Manual - Page 10
Wiring A Gate Operator(normally Open) & A Doorstrike Lock (normally Open
View all LiftMaster EL1SS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
INTRODUCTION INSTALLATION WIRING A GATE OPERATOR (NORMALLY OPEN) & A DOOR STRIKE LOCK (NORMALLY OPEN) The door strike can be connected to Relay 1 or Relay 2. See the Programming section for information about configuring Relays 1 and 2. TESTING PROGRAMMING • Wire connectors can be removed to simplify wiring. • DO NOT overload wire connectors. Use ONLY one wire per hole. AC or DC Power Door Strike NOTE: Do not use the unit's power supply for the door strike. NOTE: For DC power install a 1N4001 diode or equivalent. NOTE: For AC power install a Siemens S10K30 MOV (Metal Oxide Varistor) or equivalent. COM (Common) NO (Normally Open) COM (Common) NO (Normally Open) Primary Gate Operator (Strike Open Input) 8
INTRODUCTION
PROGRAMMING
TESTING
INSTALLATION
8
Primary Gate Operator
(Strike Open Input)
COM
(Common)
NO
(Normally Open)
NOTE
: For DC power
install a 1N4001 diode
or equivalent.
NOTE
: For AC power install a
Siemens S10K30 MOV
(Metal Oxide Varistor) or equivalent.
AC or DC
Power
COM (Common)
NO (Normally Open)
NOTE
: Do not use
the unit’s power supply
for the door strike.
Door Strike
WIRING A GATE OPERATOR
(NORMALLY OPEN) & A DOOR
STRIKE LOCK (NORMALLY OPEN)
The door strike can be connected to Relay 1 or Relay 2. See
the
Programming
section for information about configuring
Relays 1 and 2.
•
Wire connectors can be
removed to simplify wiring.
•
DO NOT overload wire
connectors. Use ONLY one
wire per hole.