LiftMaster 8500W Owners Manual - Page 13
Install myQ RemoteLED Light
View all LiftMaster 8500W manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
Installation IMPORTANT INSTALLATION INSTRUCTIONS To reduce the risk of SEVERE INJURY or DEATH: • This portable luminaire has a polarized plug (one blade is wider than the other) as a feature to reduce the risk of electric shock. • This plug will fit in a polarized outlet ONLY one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. •. DO NOT alter the plug. •. Light is intended for ceiling or wall mount and indoor applications ONLY. 6 Install myQ Remote LED Light The myQ Remote LED Light is designed to plug directly into a standard 120V outlet. Select an appropriate location on the ceiling or wall to mount the light within 6 feet (1.83 m) of an electrical outlet so that the cord and light are away from moving parts. NOTE: If installing light on drywall and a ceiling joist cannot be located, use drywall anchors provided. No pilot hole is required for drywall anchors. 1. Drill pilot holes 6-1/8" (15.6 cm) apart if mounting to joist. OR Screw in drywall anchors 6-1/8" (15.6 cm) apart if mounting to drywall. 2. Determine the length of power cord needed to reach the nearest outlet. Wind any excess cord around cord retainer on the top side of the light base. Route the cord through the channel so the light mounts flush. 3. Open the light lens. 4. Mount the light with the screws provided. 5. Close the light lens. 6. Plug in the light to the outlet. NOTE: The LED light is very bright. DO NOT stare at the light while on a ladder. Your garage door opener remote light has already been programmed at the factory to operate with your opener. Any additional or replacement remote lights will need to be programmed. HARDWARE Drywall Anchor (screw-in) (2) Screw #6x1" (2) Cord Retainer Channel 6-1/8" (15.6 cm) Drywall Anchors Light Lens Screws 13