Lexmark C770n Service Manual - Page 111
Ready bin, full message-may be able to clear message and will feed paper into bin, selected.
UPC - 734646001151
View all Lexmark C770n manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 111 highlights
5061 Step 5 Actions and questions Voltage check, base printer autoconnect connector- Turn the power off, and remove the output option from the printer. Check the voltages on the base printer top autoconnect connector. See "Autoconnect-bottom" on page 5-19. Are the voltages correct? Yes Replace the output option. No Replace the bottom option autoconnect cable. Ready bin x full message-may be able to clear message and will feed paper into bin selected. Note: This sensor is normally in a open position with the flag out of the sensor slot. Step 1 2 3 4 Actions and questions Bin x sensor (bin x=Sensor 1 through 5)-Make sure the sensor is seated correctly in the side of tray x. Is the sensor seated correctly? Bin x sensor cable-Make sure that bin x sensor cable is connected to the sensor and to the control board. Is the sensor cable connected correctly? Bin x sensor flag-Check the bin x sensor flag for binding and proper operation. Are there any problems with the sensor flag? Bin x sensor cable-Check the continuity of the sensor cable. Is there continuity? Yes Go to step 2 Go to step 3 Repair or replace the sensor flag. Replace the bin x sensor. No Install the sensor correctly. Install the sensor cable correctly. Go to step 4 Replace the bin x cable. Bin x full-no message that bin x is full message Step Actions and questions 1 Bin x sensor (bin x=sensor 1 through 5)-Make sure the sensor is seated correctly in the side of tray x. Is the sensor seated correctly? 2 Bin x sensor cable-Make sure that bin x sensor cable is connected to the sensor and to the control board. Is the sensor cable connected correctly? 3 Bin x sensor flag-check the bin x sensor flag for binding and proper operation. Are there any problems with the sensor flag? 4 Bin x sensor cable-Check the continuity of the sensor cable. Is there continuity? Yes Go to step 2 Go to step 3 Repair or replace the sensor flag. Replace the bin x sensor. No Install the sensor correctly. Install the sensor cable correctly. Go to step 4 Replace the bin x cable. Diagnostic information 2-69