Lexmark C770n IPDS Emulation User’s Guide - Page 56
Stapling, 5.2.1 AS/400 and iSeries Stapling
UPC - 734646001151
View all Lexmark C770n manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 56 highlights
5.2 Stapling Stapling is available when an optional finisher is installed. When stapling is specified in the IPDS job, the job bin selection will be ignored and the job will be routed to a bin that supports stapling. Jobs are stapled according to the following printer and finisher restrictions. It is the user's responsibility to load a media type and size that can be stapled by the optional finisher. Refer to your printer documentation for media types and sizes supported by the optional finisher and for any additional restrictions that may apply. • Jobs that exceed the maximum staple packet size may or may not be stapled. Results will be different for different finisher units. • Stapling has a higher priority than output bin selection. • Stapling and hole punch may be performed on the same job. Note: The Staple Job menu item under the printer's Settings > Finishing Menu does not affect stapling of IPDS jobs. 5.2.1 AS/400 and iSeries Stapling Stapling is controlled in the printer file parameters on the AS/400 and iSeries. Printer files may be created using the 'CRTPRTF' command or changed using the 'CHGPRTF' command. Check to see that all PTFs that affect stapling have been applied before calling for technical support. Finishing capabilities for optional finishers vary. Differences are explained below. 56