LevelOne GEL-2461 Manual - Page 13
Connecting Network Devices
View all LevelOne GEL-2461 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
Chapter 2 Hardware Installation Figure 2-1 Installing the Switch in a Rack 2.2.2 Installing the Switch on a Level Surface To install the Switch on a level surface (such as a desktop or shelf), follow these steps: Step 1 Place the Switch upside down on a sturdy, flat surface with a power outlet nearby. Step 2 Remove the adhesive backing from the supplied rubber feet. Attach the four rubber feet to the four round recessed areas on the bottom of the Switch. Step 3 Turn the Switch over to make it right side up on the flat surface. 2.3 Connecting Network Devices To connect network devices to the GEL-2461 Switch, follow these steps: Step 1 Make sure all devices you will connect to the Switch are powered off. Step 2 Connect a standard network cable from an available port on the Switch to a PC or other network device. Step 3 Repeat step 2 to connect rest network devices. Note All RJ-45 ports on the Switch support auto MDI/MDI-X feature. This means that you can use either a crossover cable or straight-through cable to connect a device to the Switch. http://www.level1.com Page 6