Lantronix SLC 8000 Advanced Console Manager User Guide - Page 288
connect direct, Key Sequences on Local and Remote, User Settings
![]() |
View all Lantronix SLC 8000 Advanced Console Manager manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 288 highlights
12: User Authentication Enable for Dial-back Select to grant a local user dial-back access. Users with dial-back access can dial into the SLC unit and enter their login and password. Once the SLC 8000 advanced console manager authenticates them, the modem hangs up and dials them back. Disabled by default. Dial-back Number The phone number the modem dials back on depends on this setting for the device port. The user is either dialed back on a fixed number (specified on the Device Port - Settings page), or on a number that is associated with the user's login (specified here). Escape Sequence A single character or a two-character sequence that causes the SLC unit to leave direct (interactive) mode. (To leave listen mode, press any key.) A suggested value is Esc+A (escape key, then uppercase "A" performed quickly but not simultaneously). You would specify this value as \x1bA, which is hexadecimal (\x) character 27 (1B) followed by an A. This setting allows the user to terminate the connect direct command on the command line interface when the endpoint of the command is deviceport, tcp, or udp. See Key Sequences on page 258 for notes on key sequence precedence and behavior. Break Sequence A series of 1-10 characters users can enter on the command line interface to send a break signal to the external device. A suggested value is Esc+B (escape key, then uppercase "B" performed quickly but not simultaneously). You would specify this value as \x1bB, which is hexadecimal (\x) character 27 (1B) followed by a B. See Key Sequences on page 258 for notes on key sequence precedence and behavior. Custom Menu If custom menus have been created, you can assign a default custom menu to the user. The custom menu will display at login. Note: In the Local Users table, if the menu assigned to a local user no longer exists, it is marked with an asterisk (*). Display Menu at Login If custom menus have been created, select to enable the menu to display when the user logs into the CLI. Password / Retype Password When a user logs into the SLC 8000 advanced console manager, the SLC unit prompts for a password (up to 64 characters). The sysadmin establishes that password here. Password Expires If not selected, allows the user to keep a password indefinitely. If selected the user keeps the password for a set period. (See the section, Local and Remote User Settings (on page 284) for information on specifying the length of time before the password expires.) Allow Password Change Select to allow the user to change password. Change Password on Next Login Indicate whether the user must change the password at the next login. Lock Account Select to lock the account indefinitely. Account Status Displays the current account status: Active Locked Locked (invalid logins) SLC™ 8000 Advanced Console Manager User Guide 288
![](/manual_guide/products/lantronix-slc-8000-advanced-console-manager-user-guide-28e8c8e/288.png)