Lantronix PNT Series PNT-SG3FS GNSS Module Software User Guide - Page 98

11. Commands Parameter Format Description bit 7: BEIDOU constellation enabling/disabling EHPE threshold Decimal, 3 digits EHPE average threshold [m] Max tracked sats Decimal, 2 digits First N satellites (with higher elevation) used for the position calculation (Activechannel management) in LOW POWER STATE Switch constellation Decimal, 1 digitSwitch constellation features (enable it only for GNSS constellation features case) Cyclic mode settings Duty Cycle enable/ disable Decimal, 1 digitEnable/Disable the Cyclic mode 0: OFF, 1: ON This parameter can only be enabled if "Periodic mode" parameter is 0 Duty Cycle fix period Decimal, 1 digit Time between 2 fixes Typical value: 1, 3, 5 The receiver provide a fix every fix period Periodic mode settings Periodic mode Decimal, 1 digitSetup Active or Standby periodic mode 0: OFF 3: Standby Periodic mode FixPeriod Decimal, 5 digits Interval between two fixes [s]. 0 means no periodic fix is required. FixOnTime Decimal, 2 digits Number of fixes reported for each interval Ephemeris refresh Decimal, 1 digitEnable/Disable the refresh of ephemeris data 0: OFF, 1: ON RTC calibration Decimal, 1 digitEnable/Disable the RTC calibration 0: OFF, 1: ON NoFixCnt Decimal, 2 digits Time to declare fix loss [s] in HOT conditions NoFixOff Decimal, 2 digits Period of off period after a fix loss [s]. 0 means the counter is not active. The fix retry will be based on FixPeriod. Results:  In case of no errors, the $PSTMLOWPOWERON message is returned.  In case of errors, the $PSTMLOWPOWERERROR error message is returned PNT-SG3FS GNSS Module Software User Guide 98