Konica Minolta AccurioLabel 190 bizhub PRESS C71cf/AccurioLabel 190 Quick Guid - Page 111
If a Meandering Paper Has Occurred, STEP 2: Checking the Position of the Media and Parts
View all Konica Minolta AccurioLabel 190 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 111 highlights
Accurio Label 190/bizhub PRESS C71cf If a Meandering Paper Has Occurred A meandering paper may result in the edge of paper being damaged or images being out of alignment. If a meandering paper occurs, check the following: - The tension applied on the media is not correct. - The media or other parts (such as guides on the roller) are not set in the right position. - The conveyer section is dirty with adhesive. Follow the procedures below to solve the problem: STEP 1: Checking the Media Tension Check if the tension setting of the media has been made properly. % For details, refer to page 3-13. STEP 2: Checking the Position of the Media and Parts Check if the media or other parts set in the right position. % For details, refer to page 4-16. STEP 3: Cleaning the Adhesive Sticking on the Parts Clean the media guides and the restriction guides on the leading section if it is dirty with adhesive. % For details, refer to page 4-4. STEP 4: Adjusting the Position of the Aligning Roller If media meandering is not yet resolved in up to STEP 3, adjust the position of the aligning roller. % For details, refer to page 5-18. STEP 5: Changing the Tension Setting If the error persists after the procedure mentioned above is performed, raise the tension by one level. % For details, refer to page 5-20. 5 5-17