KitchenAid UXT4030ADS Use & Care Guide - Page 14

For non-vented (recirculating) installations: The charcoal filter is not washable. It should last up to 6 months with normal use. 1. Replace metal grease filter with a charcoal filter. For information on ordering, see the "Accessories" section. To replace filter: 1. Remove screw from the grease filter retainer. 2. Turn the grease filter retainer to release filter. 3. Reinstall the filter by placing the back edge in the channel at rear of hood. Push filter into place, turn the filter retainer to secure filter to range hood. 4. Replace screw in the grease filter retainer. Replacing the Incandescent Light Bulb Turn off the range hood and allow the light bulb to cool. 1. Disconnect power. 2. Squeeze the plastic lens cover and remove it from the hood. AB A. Light bulb socket B. Lens cover 3. Screw light bulb into socket. 4. Replace lens cover by squeezing cover and inserting tabs into slots. 5. Reconnect power. If new light does not operate, make sure the lamp is inserted correctly before calling service. WIRING DIAGRAM R Motor Switch Off - On BK Lamp Switch Off - Low - High 1 2 Lamp Switch Operation 1 - 2 Off L 3 1 - 3 Low 1 - L High Rectifier Diode W R NOTE: Speed 1 not used W BK BK BK W R Y Speed 1 W Common Speed 2 R BK C25 Motor Characteristics Power Supply 120 VAC Frequency 60 Hz Amperage 1.2 ±10% A Wattage Rating 73 ±10% Watts Motor Resistance White - Red 17.1 ±10% Ohms White - Black 13.6 ±10% Ohms Ground Screw L N GND SE114A 14