KitchenAid KXU2830JSS Owners Manual - Page 13
Range Hood Care
View all KitchenAid KXU2830JSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
RANGE HOOD CARE Cleaning IMPORTANT: Clean the range hood and grease filter frequently according to the following instructions. Replace grease filter before operating range hood. Be sure light is cool before cleaning the range hood. Exterior Surfaces Clean the range hood with a mild detergent and soft cloth. To avoid damage to the exterior surface, do not use abrasive cleansers or steel-wool pads To Install Charcoal Filter 1. For non-vented (recirculating installations), fit the charcoal filter on the rear side of the metal grease filter. 2. Secure the charcoal filter in place with the metal brackets supplied. BC A Metal Grease Filter The filter should be washed frequently. Place metal filter in dishwasher or hot detergent solution to clean. Let filter dry thoroughly before replacing it. Turn off fan and lights. Allow the LED lamp to cool. 1. Remove the filter by pulling the spring release handle and then pulling down the filter. A A. Metal brackets B. Charcoal filter C. Metal grease filter 3. Reinstall the filter assembly into the range hood. To Replace Charcoal Filter 1. Turn fan and lights off. Check that the LED lamp is cool. 2. Remove the metal grease filter. See the "Metal Grease Filter" section. 3. Remove the brackets and remove the charcoal filter. 4. Clean or discard the charcoal filter. 5. Install the cleaned or replacement filter. A. Spring release handle 2. Wash the metal filter as needed in the dishwasher or hot detergent solution. 3. Reinstall the filter by making sure the spring release handle is toward the front. Insert the metal grease filter into the upper track. 4. Pull the spring release handle down. 5. Push up on the metal filter and release the handle to latch into place. Charcoal Filter - For Non-Vented (recirculating) Installations NOTE: After approximately 3 years of use the charcoal filter should be replaced. To order a replacement Charcoal Filter Kit, see the "Assistance or Service" section. The charcoal filter can be cleaned and reactivated. Clean the filter in the dishwasher using normal detergent and the highest temperature setting. To reactivate the filter, dry the filter in an oven for 10 minutes at a maximum temperature of 210°F (100°C). Replacing the LED Lamp 1. Disconnect power. 2. Allow LED lamp to cool before replacing. a. Use a small screwdriver as a lever on the borders of the LED lamp frame in order to slide it out. b. Replace LED lamp with a 12-volt, 3-watt maximum, LED lamp made for a GU-4 base.. c. Connect LED lamp to connector, snap LED lamp into frame and fit on its housing again (snap fixing). a a a b c 13