KitchenAid KGRS202BSS Use & Care Guide - Page 16

OVEN RACKS Cleaning Method: ■ Steel-wool pad ■ For racks that have discolored and are harder to slide, a light coating of vegetable oil applied to the rack guides will help them slide. STORAGE DRAWER OR WARMING DRAWER (on some models) Check that storage or warming drawer is cool and empty before cleaning. Cleaning Method: ■ Mild detergent OVEN CAVITY Use AquaLift™ Technology regularly to clean oven spills. Do not use oven cleaners. Food spills should be cleaned when oven cools. At high temperatures, foods react with porcelain and staining, etching, pitting or faint white spots can result. Cleaning Method: ■ Clean cycle: See "Clean Cycle" section. Oven Light The oven light is a standard 40-watt appliance bulb. Before replacing, make sure the oven and cooktop are cool and the control knobs are in the off position. 2. Turn the glass bulb cover in the back of the oven counterclockwise to remove. 3. Turn bulb counterclockwise to remove from socket. To Replace: 1. Unplug range or disconnect power. 4. Replace bulb, then bulb cover by turning clockwise. 5. Plug in range or reconnect power. TROUBLESHOOTING First try the solutions suggested here or visit our website and reference FAQs (Frequently Asked Questions) to possibly avoid the cost of a service call. www.kitchenaid.com In Canada, reference the Customer Service section at www.kitchenaid.ca. WARNING PROBLEM Nothing will operate Surface burners will not operate 16 Electrical Shock Hazard Plug into a grounded 3 prong outlet. Do not remove ground prong. Do not use an adapter. Do not use an extension cord. Failure to follow these instructions can result in death, fire, or electrical shock. POSSIBLE CAUSES Power supply cord is unplugged. Household fuse is blown or a circuit breaker is tripped. Main or regulator gas shutoff valve is in the off position. The range is improperly connected to the gas supply. The control knob is not set correctly. Air in the gas lines Clogged burner ports SOLUTIONS Plug into a grounded 3 prong outlet. Replace the fuse or reset the circuit breaker. If the problem continues, call an electrician. See the Installation Instructions. Contact a trained repair specialist or see Installation Instructions. Push in knob before turning to a setting. If this is the first time the surface burners have been used, turn on any one of the surface burner knobs to release air from the gas lines. See "Sealed Surface Burners" section.