KitchenAid KFDC500JSS Installation Instructions - Page 10
Awarning
View all KitchenAid KFDC500JSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Install Anti-Tip Bracket WARNING Partially close the door to engage the door latch locks. The door will stop at this point. Use two hands to remove and replace the oven door(s). It may be necessary to gently shift door from side to side. A A. Slot in the oven frame for the door hinge lock Replace the Door ■ To replace the oven door(s), locate the slots in the oven cavity for the hinge locks and repeat the steps above in reverse order. Make sure the door closes properly and there is no interference from the door latch. If necessary, remove the door and repeat the steps above. If power is connected to the range, open and close the door to make sure the oven light comes on and goes off appropriately. ■ The range is equipped with leveling legs and rollers. Once the range is removed from the shipping pallet, make sure the leveling legs are not touching the floor and use the rollers to move the range into position. Always cover the flooring surface to avoid damage to the floor. Do not roll the range directly on the floor. Tip Over Hazard A child or adult can tip the range and be killed. Install anti-tip bracket to floor or wall per installation instructions. Slide range back so rear range foot is engaged in the slot of the anti-tip bracket. Re-engage anti-tip bracket if range is moved. Do not operate range without anti-tip bracket installed and engaged. Failure to follow these instructions can result in death or serious burns to children and adults. 1. Determine which mounting method to use: floor or wall. If you have a stone or masonry floor, you can use the wall mounting method. 2. Determine and mark centerline of the cutout space. The mounting bracket must be installed on the left side of the cutout. Position mounting bracket in cutout as shown in the following illustration. Measurement B: 30" (76.2 cm) ranges: 13" (33.0 cm) 36" (91.4 cm) ranges: 16" (40.6 cm) 48" (121.9 cm) ranges: 22" (55.9 cm) Measurement C: Optional distance from back wall. If back wall is constructed of a combustible material and a backguard is not installed, a 6" (15.2 cm) minimum clearance is required for all models. Install anti-tip bracket accordingly. C A B A. Centerline B. Centerline of cutout to outside edge of anti-tip bracket C. Back wall to back of range 10