Kenwood XD-853 User Manual - Page 61

General, Remote control unit, For the U.S.A., FCC WARNING, Note to CATV system installer, CAUTION

Get Kenwood XD-853 PDF manuals and user guides View all Kenwood XD-853 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 61 highlights

In case of difficulty 61 Remote control unit Symptom Cause Remedy Remote control operation is not possible. ÷ Batteries are exhausted. ÷ The remote control is too far away from the system, the controlling angle is deviated or there is an obstacle in between. ÷ There is no tape or CD set in the component to be played. ÷ An attempt is made to play the cassette deck which is recording something. ÷ The MULTI CONTROL setting mode is activated. ÷ Replace with new batteries. $ ÷ Operate the unit within the remote controllable range. $ ÷ Set a tape or CD in the component to be played. ÷ Wait until the recording ends. ÷ Cancel the MULTI CONTROL setting mode. % General Symptom Cause Remedy No operation occurs when ÷ The MULTI CONTROL setting mode ÷ Cancel the MULTI CONTROL setting an operation key is pressed. is activated. mode. % For the U.S.A. CAUTION : Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure. In compliance with Federal Regulations, following are reproductions of labels on, or inside the product relating to laser product safety. KENWOOD CORPORATION 2967-3, ISHIKAWA-CHO, HACHIOJI-SHI,TOKYO, JAPAN KENWOOD CORP. CERTIFIES THIS EQUIPMENT CONFORMS TO DHHS REGULATIONS NO. 21 CFR 1040.10, CHAPTER 1, SUBCHAPTER J. Location: Back Panel Note to CATV system installer This reminder is provided to call the CATV system installer's attention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical Knowledge section FCC WARNING This equipment may generate or use radio frequency energy. Changes or modifications to this equipment may cause harmful interference unless the modifications are expressly approved in the instruction manual. The user could lose the authority to operate this equipment if an unauthorized change or modification is made. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment may cause harmful interference to radio communications, if it is not installed and used in accordance with the instructions. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna. -- Increase the separation between the equipment and receiver. -- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -- Consult the dealer or an experienced radio / TV technician for help.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
61
Knowledge section
In case of difficulty
Remedy
Symptom
Cause
General
Remote control operation is
not possible.
÷
Batteries are exhausted.
÷
The remote control is too far away
from the system, the controlling angle
is deviated or there is an obstacle in
between.
÷
There is no tape or CD set in the
component to be played.
÷
An attempt is made to play the cas-
sette deck which is recording some-
thing.
÷
The MULTI CONTROL setting mode
is activated.
÷
Replace with new batteries.
÷
Operate the unit within the remote
controllable range.
÷
Set a tape or CD in the component to
be played.
÷
Wait until the recording ends.
÷
Cancel the MULTI CONTROL setting
mode.
Remote control unit
Remedy
Symptom
Cause
No operation occurs when
an operation key is pressed.
÷
The MULTI CONTROL setting mode
is activated.
÷
Cancel the MULTI CONTROL setting
mode.
CAUTION :
Use of controls or adjustments or performance of proce-
dures other than those specified herein may result in
hazardous radiation exposure.
In compliance with Federal Regulations, following are
reproductions of labels on, or inside the product relating to
laser product safety.
For the U.S.A.
Location: Back Panel
FCC WARNING
Note to CATV system installer
KENWOOD CORPORATION
2967-3, ISHIKAWA-CHO,
HACHIOJI-SHI,TOKYO, JAPAN
KENWOOD CORP. CERTIFIES THIS EQUIPMENT
CONFORMS TO DHHS REGULATIONS NO. 21 CFR
1040.10, CHAPTER 1, SUBCHAPTER J.
This reminder is provided to call the CATV system installer's
attention to Article 820-40 of the NEC that provides guide-
lines for proper grounding and, in particular, specifies that
the cable ground shall be connected to the grounding sys-
tem of the building, as close to the point of cable entry as
practical
NOTE:
This equipment may generate or use radio frequency energy. Changes or modifications to this equipment may cause harmful
interference unless the modifications are expressly approved in the instruction manual. The user could lose the authority
to operate this equipment if an unauthorized change or modification is made.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential instal-
lation. This equipment may cause harmful interference to radio communications, if it is not installed and used in accor-
dance with the instructions. However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
–– Reorient or relocate the receiving antenna.
–– Increase the separation between the equipment and receiver.
–– Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
–– Consult the dealer or an experienced radio / TV technician for help.
$
$
%
%