Kenwood VR-8070 Instruction Manual - Page 47

In case of difficulty Remote control unit Symptom Certain inputs cannot be selected using the remote control. Remote control operation is not possible. Cause Remedy • No setup codes registered for the respective • Register a setup code at the respective input(s). input(s). , • The remote control is set to a different operation mode. • Batteries are exhausted. • The remote control unit is too far away from the main system, controlling angle is too large, or there is an obstacle between the receiver and the remote. • No tape or CD is placed in the source component. • An attempt is made to play a tape which is being recorded in the cassette deck. • The remote control has not been set to the operation mode for the component you wish to control. • Press any of the Input Selector keys to select the appropriate operation mode. • Replace with new batteries. • Operate the remote control unit within the controllable range. • Place the tape or CD in the source component which you want to play. • Wait until recording has completed. • Press any of the source keys or SRC Power key to activate the operation mode for the component you want to control before operation. · 47 EN