Kenwood TM-D710GE Instruction Manual - Page 41
Packet-3, Tnc Commands List
View all Kenwood TM-D710GE manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 41 highlights
TNC COMMANDS LIST The commands supported by the built-in TNC are listed below. You must enter a space between a command name (or short-form) and a parameter, or between two parameters; ex. AU OFF, BEACON EVERY 18. Command Name 8BITCONV AFILTER AUTOLF AXDELAY AXHANG BEACON BTEXT CALIBRAT CHECK CONMODE CONNECT CONOK CONSTAMP CONVERSE CPACTIME CR DAYSTAMP DAYTIME DAYUSA DIGIPEAT DISCONNE Short 8 AF AU AXD AXH B BT CAL CH CONM C CONO CONS CONV or K CP CR DAYS DA DAYU DIG D Description Parameter When ON, handles one character using 8 bits in Converse mode. When OFF, handles one character using 7 bits. ON/ OFF Specifies up to 4 control codes to be removed from received packets when in Converse mode. $00 ~ $80 When ON, sends a line feed (LF) to the computer after each carriage return (CR). ON/ OFF Specifies the delay time to be added to TXDELAY between PTT ON and start of transmission. The unit of the parameter is 10 milliseconds. 0 ~ 120 Specifies the voice repeater hang time. The unit of the parameter is 100 milliseconds. 0 ~ 250 If set to EVERY, sends a beacon packet at intervals of the specified period (n). If set to AFTER, sends a beacon packet only once after the specified period (n). The unit of n is 10 seconds. EVERY/ AFTER n (n = 0 ~ 250) Specifies the content of the data portion of a beacon packet. 0 ~ 159 characters Sends a space/mark square wave (50/50 ratio). Enter Q to exit Calibrate mode and restore the Command mode. − Specifies the interval from signal drop-out until execution of disconnection. The unit of the parameter is 10 seconds. 0 ~ 250 With NOMODE set to OFF, causes the TNC to automatically enter Converse or Transparent mode when connection is C/ T completed. Sends a connect request. Call1 is the callsign of the station to be connected to. Call2 to call9 are callsigns of stations to be digipeated through. Call1 (VIA call2, call3, ... call9) When ON, accepts a connect request and returns a UA packet. When OFF, rejects a connect request and returns a DM packet. ON/ OFF When ON, displays the current date and time when connection is completed. The correct date and time must be set using DAYTIME. ON/ OFF Causes the TNC to enter Converse mode. Press [Ctrl]+[C] to restore the Command mode. − When ON and in Converse mode, sends a packet at intervals of the period determined by PACTIME. ON/ OFF When ON, appends a carriage return (CR) to all packets to be sent. ON/ OFF When ON, pressing [Ctrl]+[T] in Converse mode causes the TNC to send date data in addition to time data. ON/ OFF Sets the current date and time. Enter YYMMDDhhmmss. Sets 00 as the second if entry of the second is omitted. − When ON, displays the date like MM/DD/YY. When OFF, displays the date like DD-MM-YY. ON/ OFF When ON, allows the TNC to function as a digipeater. ON/ OFF Sends a disconnect request. − Default ON $00 ON 0 0 EVERY 0 − − 30 C − ON OFF − OFF ON OFF − ON ON − PACKET-3