Kenwood TM-D710E User Manual 1 - Page 12
Replacing Fuses, Operation Panel And Microphone Connection
View all Kenwood TM-D710E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
REPLACING FUSES If the fuse blows, determine the cause, then correct the problem. After the problem is resolved, replace the fuse. If newly installed fuses continue to blow, disconnect the power cable and contact your authorized Kenwood dealer or an authorized Kenwood service center for assistance. Fuse Location Fuse Current Rating Transceiver (located on the DC connector) 15 A Supplied DC power cable 20 A Only use fuses of the specified type and rating; otherwise the transceiver could be damaged. Fuse holder (E type) Fuse Fuse holder (K, M4 types) Fuse holder Fuse Fuse holder OPERATION PANEL AND MICROPHONE CONNECTION Plug the microphone plug into the MIC jack, then connect the Operation panel to the TX/ RX unit with the supplied cable. • Attach the microphone hanger to an appropriate position using the screws included in the screw set. Microphone TX/ RX unit Installing the Line Filter Install the line filters approximately 3 cm from the connectors. Approx. 3 cm MIC jack Line filter Panel jack Modular plug cable Line filter 6 Operation panel