Kenwood NX-340 Operation Manual - Page 20

Selecting A Zone And Channel, Transmitting, Receiving

Get Kenwood NX-340 PDF manuals and user guides View all Kenwood NX-340 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 20 highlights

SELECTING A ZONE AND CHANNEL 1 Select the desired zone using the key programmed as [Zone Up] or [Zone Down]. • Each zone contains a group of channels. 2 Select the desired channel using the Channel selector. • Each channel is programmed with settings for transmitting and receiving. TRANSMITTING 1 Select the desired zone and channel. 2 Press the key programmed as [Monitor] or [Squelch Off] to check whether or not the channel is free. • If the channel is busy, wait until it becomes free. 3 Press the PTT switch and speak into the microphone. Release the PTT switch to receive. • For best sound quality, hold the transceiver approximately 1.5 inches (3 ~ 4 cm) from your mouth. RECEIVING Select the desired zone and channel. If signaling has been programmed on the selected channel, you will hear a call only if the received signal matches your transceiver settings. Note: Signaling allows your transceiver to code your calls. This will prevent you from listening to unwanted calls. Refer to "SIGNALING" on page 17 for details. 12

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
12
SELECTING A ZONE AND CHANNEL
1
Select the desired zone using the key programmed as
[Zone Up]
or
[Zone Down]
.
•
Each zone contains a group of channels.
2
Select the desired channel using the
Channel
selector.
•
Each channel is programmed with settings for transmitting and
receiving.
TRANSMITTING
1
Select the desired zone and channel.
2
Press the key programmed as
[Monitor]
or
[Squelch Off]
to check whether or not the channel is free.
•
If the channel is busy, wait until it becomes free.
3
Press the
PTT
switch and speak into the microphone.
Release the
PTT
switch to receive.
•
For best sound quality, hold the transceiver approximately
1.5 inches (3 ~ 4 cm) from your mouth.
RECEIVING
Select the desired zone and channel. If signaling has been
programmed on the selected channel, you will hear a call only
if the received signal matches your transceiver settings.
Note:
Signaling allows your transceiver to code your calls. This will
prevent you from listening to unwanted calls. Refer to “SIGNALING”
on page 17 for details.