Kenwood HM-437MP User Manual - Page 8

ENGLISH Basic function Demonstration mode The system is equipped with a demonstration function (only display). The demonstration consists of sequential change of display and indicators showing the operations, but the audio itself does not change. The demonstration function can be cancelled as follows. To deactivate the demonstration Press and hold rec button (REC/DEMO button on the remote control) for more than 0.8 seconds during demonstration. To activate the demonstration After turning the power on, press and hold rec button (REC/DEMO button on the remote control) for more than 0.8 seconds. Note: The demonstration operates automatically when a power failure has occurred, or the plug of the power cable has been pulled out while the power was on. Switching the system on Press button on the unit or POWER button on the remote control; or CD, TUNER/band (TUNER/BAND on the remote control), or TAPE button. The standby led will go out. • The system will switch to the last selected source or the selected source. Switching the system to standby mode Press button on the unit or POWER button on the remote control. • The clock will be displayed. Volume control Press volume ∧ button on the unit ( VOLUME UP 5 button on the remote control) to increase, or press volume ∨ button on the unit ( VOLUME DOWN ∞ button on the remote control) to decrease the volume level. "VOL XX" will be displayed. "VOL XX" denotes the volume level. The volume can be adjusted in 32 steps from minimum to maximum. To switch off the volume temporarily Press MUTE button on the remote control. Playback will continue without sound only system speaker output and the icon "MUTE" appears on the display. To restore the volume, press MUTE button on the remote control again or adjust the volume. Sound control EQ/X-BASS The sound control system feature enables you to enjoy special sound effects that have preset equalizer settings, providing the best music reproduction. Press EQ/X-BASS button To select the desired sound effect: POP, CLASSIC, ROCK, JAZZ or FLAT. To switch the X-BASS on/off Press and hold the EQ/X-bass button on the unit (EQ/X-BASS button on the remote control). If X-BASS is switched on, "BASS ON" will appear then disappear on the display and the icon "XBASS" will appear on the display. If X-BASS is switched off, "BASS OFF" will appear then disappear on the display and the icon "X-BASS" will disappear. Note: EQ and X-BASS functions are not applied to the recording sound. Headphones To listen to your stereo with headphones (not included), use the 3.5 mm phones jack on the top of the unit. 8 EN