Jenn-Air JJD3024HM Installation Instructions - Page 4

3. Align each trim structure/surface assembly with the cabinet as shown and attach each with four Phillips screws. Alignment with front surface Install Electric Built-in Single Oven or Microwave 1. Follow the oven Installation Instructions to complete installation. NOTE: If the built-in oven was not installed into the cabinet, read the "Electrical Requirements" and "Electrical Connection" sections, along with all other sections of the Installation Instructions, before installing the oven. 2. Using two or more people, push against the seal area of the front frame to push the oven into the cabinet until the back surface of the front frame touches the Trim structure. A B Alignment with C side surface A. Trim structure B. Mounting Jig C. Trim surface 4. Adjust the trim structure/surface assemblies horizontally to touch the side surfaces of the mounting jig. Tighten the hex-head screws at the top of each assembly. B A B A. Mounting jig B. Trim structure/surface assembly 5. Remove the mounting jig from the cabinet opening. Tighten the hex-head screws at the bottom of each trim structure/ surface assembly. 3. Securely fasten oven to the metal trim structure using the screws provided. Insert the self drilling screws through hole in the side trim cover. Do not over tighten screws. 4. Reconnect power. 5. If the display panel does not light, reference the "Assistance or Service" section of the Use and Care Guide, or contact the dealer from whom you purchased your oven. Install Coffee System Install the Mounting Brackets 1. Make side wooden blocks with the dimensions as shown. D E A B C A. F or 27" (68.6 cm) cabinet: 29⁄16" (6.6 cm) For 30" (76.2 cm) cabinet: 41⁄16" (10.4 cm) (Cabinet Interior width - 221⁄16")/2 B. 13⁄16" (3 cm) C. 15⁄16" (3.4 cm) D. 163⁄4" (42.5 cm) E. 21⁄16" (5.3 cm) 2. Secure the side wooden blocks to the side walls of the cabinet and wooden bottom spacer so that the coffee system can be installed as per the Installation Instructions. A A. Trim structure/surface assembly 4 (55.292++01./0176"cm)