Jenn-Air JBRFR30IG Installation Instructions - Page 22
If You Have Questions About Your Water Supply, Call A Licensed, Qualified Plumber.
![]() |
View all Jenn-Air JBRFR30IG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
SITE PREP 3. CHECK THE WATER SUPPLY Water supply meets local plumbing codes. Water shutoff in base cabinet, as shown, or accessible area. Access hole through the cabinet is within 1/2" (1.3 cm) of the rear wall. Install any additional tubing only where temperatures remain above freezing. Check for leaks. Not using a piercing-type or 3/16" (4.8 mm) saddle valve. See refrigerator dealer for saddle-type valve kit that complies with local plumbing codes. If water pressure to reverse osmosis system is less than 40 to 60 psi (276 to 414 kPa): • Check sediment filter to see if it is blocked. Replace filter if necessary. • Allow the storage tank to refill after heavy usage. • Remove the water filter cartridge. No filter bypass is necessary. WATER SUPPLY REQUIREMENTS Water Pressure 30 - 120 psi (207 - 827 kPa) Water Pressure to Reverse Osmosis System Minimum 40 - 60 psi (276 - 414 kPa) Excess Water Line for Connection 30" (76.2 cm) Supply 1/4" OD copper, braided stainless steel or PEX tubing Water shutoff Access hole (within 1/2" of rear wall) IF DEDICATED WATERLINES ARE NOT AVAILABLE FOR EACH COLUMN INSTALLED, IT IS PERMISSIBLE TO SPLIT 1 WATER LINE - 2 OR 3 WAYS DEPENDING ON NUMBER OF COLUMNS INSTALLED. ? IF YOU HAVE QUESTIONS ABOUT YOUR WATER SUPPLY, CALL A LICENSED, QUALIFIED PLUMBER. 22 I N T R O D U C T I O N
![](/manual_guide/products/jennair-jbrfl24ig-installation-instructions-6c9ea65/22.png)