Invacare PROX4F80 Operation Manual - Page 79
Replacing Non-Projection Handrims - Composite Rear, Wheels, Repairing/Replacing Pneumatic Tire/Tube
![]() |
View all Invacare PROX4F80 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 79 highlights
SECTION 11-WHEELS Replacing Non-Projection Handrims - Composite Rear Wheels NOTE: For this procedure, refer to FIGURE 11.11. 1. Remove the rear wheel from the wheelchair. Refer to Removing/Installing Rear Wheels on page 68. 2. Remove the button screws and washers that secure the handrim to the rear wheel. 3. Remove the existing handrim from the rear wheel. 4. Install the new handrim by reversing the above procedures. ƽ WARNING Make sure detent pin and locking pins of the quick/quad-release axles are fully released before operating wheelchair. Mounting Screws and Washers 5. Reinstall rear wheel to the wheelchair. Refer to Removing/Installing Rear Wheels on page 68. 6. Repeat the procedure for the opposite rear wheel if necessary. Handrim Rear Wheel FIGURE 11.11 Replacing Non-Projection Handrims - Composite Rear Wheels Repairing/Replacing Pneumatic Tire/Tube ƽ WARNING Replacement of a pneumatic tire or tube MUST be performed by a qualified technician. CAUTION As with any vehicle, the wheels, casters and tires should be checked periodically for cracks and wear, and should be replaced. Part No 1125104 79 ProSPIN™ X4™
![](/manual_guide/products/invacare-prox4f80-operation-manual-c4adc2f/79.png)