Invacare IN88AHANFRFF Owners Manual - Page 32
Replacing Rear Wheel Handrim, Replacing/Repairing Rear Wheel Tire
View all Invacare IN88AHANFRFF manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
SECTION 7-REAR WHEELS 5. Reinstall rear wheel onto the wheelchair. Refer to Removing/Installing Rear Wheels on page 30. Detent Balls Quick-Release Axle FIGURE 7.2 Adjusting Quick-Release Axle Replacing Rear Wheel Handrim NOTE: For this procedure, refer to FIGURE 7.3. 1. Remove the rear wheel from the wheelchair. Refer to Removing/Installing Rear Wheels on page 30. 2. Remove the mounting screws that secure the handrim to the rear wheel. 3. Remove the existing handrim. 4. Install the new handrim by reversing the preceding steps. Rear Wheel Handrim Mounting Screw FIGURE 7.3 Replacing Rear Wheel Handrim ƽ WARNING Make sure detent pin and detent balls of the quick-release axles are fully released before operating the wheelchair. 5. Reinstall rear wheel to the wheelchair. Refer to Removing/Installing Rear Wheels on page 30. 6. If the detent balls of the quick‐release axles (if applicable) are not protruding past the inside of the axle bushing or there is too much movement of the rear wheel assembly in a back and forth position, refer to Adjusting Quick‐Release Axle on page 31. 7. Repeat STEPS 1‐6 for the opposite rear wheel if necessary. Replacing/Repairing Rear Wheel Tire ƽ WARNING Replacement of rear wheel tire or tube MUST be performed by a qualified technician. Insignia™ 32 Part No. 1163197