Invacare IN08AHANFRFF Owners Manual - Page 21
Adjusting Footplate Height, Raising/Lowering Elevating Legrest Assembly
View all Invacare IN08AHANFRFF manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
SECTION 4-FRONT RIGGINGS Adjusting Footplate Height NOTE: For this procedure, refer to FIGURE 4.2 on page 21. NOTE: This procedure applies to the swingaway front riggings and swingaway elevating legrest. 1. Remove the front rigging assembly. Refer to Installing/Removing Front Riggings Assembly on page 20. 2. Pull the cam lock lever down to unlocked position. NOTE: The elevating legrest has two sets of release buttons, one set above the other. Each set will be visible one at a time allowing finer footplate height adjustment. 3. Push in the spring buttons and reposition the footplate assembly to the desired height. 4. Ensure that the spring buttons fully protrude from adjustment holes on both sides of the front rigging support. 5. Rotate cam lock lever up to the locked position. 6. Reinstall the swingaway front rigging assembly. Refer to Installing/Removing Front Riggings Assembly on page 20. Front Rigging Support Spring Buttons (Located on both sides of each front rigging support) Adjustment Holes Cam Lock Lever (Shown in Locked Position) FIGURE 4.2 Adjusting Footplate Height Raising/Lowering Elevating Legrest Assembly NOTE: For this procedure, refer to FIGURE 4.3. ƽ WARNING Ensure hands and fingers are clear of elevating legrest mechanism before pushing release lever to lower the elevating legrest. Otherwise injury may occur due to pinch points. The user's leg MUST be supported by an assistant before attempting to lower legrest. NOTE: For this procedure, refer to FIGURE 4.3 on page 21. 1. To raise the elevating legrest, the assistant should hold the support tube and raise the elevating legrest until the desired height is obtained. 2. To lower the elevating legrest, perform the following: A. Support user leg with one hand. B. Push release lever downward with other hand. C. Gently, lower user leg down and rest against the legrest. Release Lever Support Tube FIGURE 4.3 Raising/Lowering Elevating Legrest Assembly Part No. 1163197 21 Insignia™