Invacare CRFTI Owners Manual - Page 25
Installing/Adjusting Optional Clamp on Raised Footrest, Installing, Adjusting
View all Invacare CRFTI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
SECTION 4-FOOTREST Installing/Adjusting Optional Clamp on Raised Footrest NOTE: For this procedure, refer to FIGURE 4.2. Installing 1. Install the two half clamps onto either side of the wheelchair frame approximately 2‐inches above existing footrest with two provided allen screws. 2. Repeat for the opposite side of the wheelchair. 3. Slide the clamp on raised footrest into the half clamps to the desired height. 4. Securely tighten the four allen screws. Wheelchair Frame Half Clamp Raised Footrest Allen Screws Outside Footrest Hoop FIGURE 4.2 Installing/Adjusting Optional Clamp on Raised Footrest Adjusting 1. Loosen the four allen screws. 2. Adjust clamp on raised footrest to the desired height. 3. Securely tighten the four allen screws. Replacing/Adjusting Optional Adjustable Angle Footrest NOTE: For this procedure, refer to FIGURE 4.3 on page 26. Replacing the Footrest 1. Loosen, but DO NOT remove, the allen screw of the two clamps that secure the footrest to the wheelchair frame. 2. Slide the existing footrest tubes out of the wheelchair frame and install new footrest by reversing this step. 3. Position the new footrest to a determined height. 4. Tighten the allen screw of the two clamps that secure the footrest to the wheelchair frame. 5. Adjust the footplate to the desired position. Refer to Adjusting Footplate Angle on page 26 and/or Adjusting Footplate Depth on page 26. Part No 1134872 25 Crossfire™Series Wheelchairs