Invacare 9805P Owners Manual - Page 17
CAUTION, ASSEMBLY, Assembly of the Patient Lift - Base, Mast and Boom Assembly
View all Invacare 9805P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
SECTION 4-ASSEMBLY 7. Remove the bolt and locknut from the top of the mounting bracket of the mast assembly. 8. Align the holes of the boom assembly and mast assembly mounting bracket. Insert the bolt completely through the holes of the mast assembly mounting bracket and the boom assembly. NOTE: Be sure that the bolt is completely through the holes of the mast assembly mounting bracket and boom assembly, and they are not riding on the shoulder of the bolt. CAUTION The boom and mast, when assembled, MUST pivot easily. 9. Tighten the bolt and nut using the Allen wrench provided and an adjustable wrench. NOTE: The nut and bolt can be tightened completely and the boom assembly will pivot easily if the mounting hardware is aligned properly when the boom assembly is secured to the mast. To check for correct alignment of the hardware, use the Allen wrench provided and turn the bolt by hand (it should rotate without a lot of force being applied). If excessive force is necessary, the bolt is NOT aligned properly. Disassemble and repeat assembly procedures until proper alignment is obtained. 10. To check for tightness of nut and bolt: A. Raise the boom assembly. B. Push the control handle away from the pump assembly. C. If the boom assembly pivots easily, then the nut and bolt are not too tight. D. If the boom assembly does not pivot easily or does not pivot at all, then the nut and bolt are not aligned properly. Locknut Boom Assembly Mast Assembly Mounting Bracket NOTE: Mast assembly mounting Bolt bracket, boom assembly, bolt and locknut MUST all be flush against each other FIGURE 4.2 Assembly of the Patient Lift - Base, Mast and Boom Assembly Part No 1024492 17 Portable Patient Lift and Sling