Invacare 5310IVC Owners Manual - Page 40

Cleaning the Head and Foot s, WARNING, Risk of Injury or Damage

Get Invacare 5310IVC PDF manuals and user guides View all Invacare 5310IVC manuals
Add to My Manuals
Save this manual to your list of manuals

Page 40 highlights

Invacare® Homecare Beds 1. Stand or prop each bed end in an upright position on its legs. 2. Using a mild soap/detergent and soft bristle brush or sponge, scrub all exterior surfaces. 3. Using a hose and nozzle attachment, rinse bed ends thoroughly with plain cold or warm water. Do not exceed a water temperature of 110° F. Use household tap pressure. DO NOT use pressure washers or steam cleaners. DO NOT use solvents, bleach, alcohol, petroleum products, caustic agents or highly alkaline or acidic agents to clean the bed. 4. Tip bed end from side to side to allow any collected or trapped water to drain. 5. Thoroughly towel dry bed end and all components. 6. Repeat drying process until all components are dry. Ensure that the bed end is completely dry before storing. Cleaning the Head and Foot Sections WARNING! Risk of Injury or Damage The electric motors, control box and pendant are NOT protected against the entrance of dust and liquids. - DO NOT spray liquids into any electrical components. - DO NOT wash head or foot section. - DO NOT allow electrical components to get wet. 1. Unplug the power cord of electric beds before performing maintenance. 2. Wipe down the bed with disinfectant. Allow it to dry completely. 40 1114836-H-05

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
Invacare® Homecare Beds
1.
Stand or prop each bed end in an upright position on
its legs.
2.
Using a mild soap/detergent and soft bristle brush or
sponge, scrub all exterior surfaces.
3.
Using a hose and nozzle attachment, rinse bed ends
thoroughly with plain cold or warm water.
Do not exceed a water temperature of 110° F.
Use household tap pressure.
DO NOT use
pressure washers or steam cleaners.
DO NOT use solvents, bleach, alcohol, petroleum
products, caustic agents or highly alkaline or
acidic agents to clean the bed.
4.
Tip bed end from side to side to allow any collected
or trapped water to drain.
5.
Thoroughly towel dry bed end and all components.
6.
Repeat drying process until all components are dry.
Ensure that the bed end is completely dry before
storing.
Cleaning the Head and Foot Sections
WARNING!
Risk of Injury or Damage
The electric motors, control box and pendant
are NOT protected against the entrance of dust
and liquids.
– DO NOT spray liquids into any electrical
components.
– DO NOT wash head or foot section.
– DO NOT allow electrical components to get wet.
1.
Unplug the power cord of electric beds before
performing maintenance.
2.
Wipe down the bed with disinfectant. Allow it to dry
completely.
40
1114836-H-05