Icom IC-M200 Instruction Manual - Page 20
Troubleshooting
![]() |
View all Icom IC-M200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
8 TROUBLESHOOTING PROBLEM POSSIBLE CAUSE Power does not come on when turning ON the transceiver. Power cable is improperly connected. No sound is heard from the Volume level is too low. speaker. Speaker has been exposed to water. Squelch level is too high. SOLUTION Reconnect the DC power cable correctly. REF. p. 14 Rotate [VOL] to a suitable listening p. 6 level. Drain water from the speaker. p. 8 Set squelch to the threshold point. p. 6 Cannot transmit or output power is low. Scan does not start. No beeps. Channels that are only for receive or low power are selected. Low power is selected. "TAG" channels are not set. Key beeps are OFF. Select other channels. p. 18 Push [HI/LO] on the microphone to select high power. Set the channels you want to scan as "TAG" channels. Turn ON the key beep in the Set mode. p. 6 p. 10 p. 13 17
![](/manual_guide/products/icom-icm200-instruction-manual-748e172/20.png)