Icom A16 Instruction Manual - Page 14
HEADSET CONNECTION, Using a Bluetooth® headset, Using a Bluetooth, headset
View all Icom A16 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
5 HEADSET CONNECTION ■■ Using a Bluetooth® headset (For only transceivers with the built-in Bluetooth unit) Transceivers with the built-in Bluetooth unit can operate with Bluetooth headsets. The communication range of Bluetooth is approximately 10 meters (33 ft). DDPairing with a device You can pair maximum of 4 Bluetooth headsets to the transceiver. LL These instructions describe pairing with the VS-3 Bluetooth® headset, as an example. Bluetooth® Bluetooth headset (Example: Optional VS-3) 1. Turning ON the transceiver's Bluetooth function 1. Push [FUNC], and then hold down [ENT]/[SET] for 1 second to enter the Set mode. 2. Select "BT SET," and then push [ENT]/[SET]. 3. Select "ON," and then push [ENT]/ [SET]. NOTE: ••The Bluetooth communication range may vary, depending on the environment where you operate the device. 4. Push [CLR]/[HOME] to exit the Set mode. DDElectromagnetic Interference When you use a Bluetooth device, pay attention to the following: Bluetooth devices operate in the 2.4 GHz band. The 2.4 GHz band is also used by other devices, such as Wireless LAN products, microwave ovens, RFID systems, amateur radio stations, and so on. When using this device near such devices, interference may occur, causing a decrease in communication speed, and an unstable connection. In such cases, use this device away from the other devices, or stop using those devices. 2. Entering the VS-3 Pairing mode Refer to the VS-3's instruction manual for details. 3. Pairing and connecting the Bluetooth headset 1. Push [FUNC], and then hold down [ENT]/[SET] for 1 second to enter the Set mode. 2. Select "PAIRING," and then push [ENT]/[SET]. BT SET > PAIRING ••The transceiver searches for a headset. LL Push [CLR] to cancel searching. ••"SUCCESS" and " " is displayed if the headset or device is correctly connected. 3. Push [CLR]/[HOME] twice to exit the Set mode. BASIC MANUAL 9