Husqvarna 1830EXLT Owners Manual - Page 7
Install Traction Drive Control Rod, See Figs. 3 And 4, Install Auger Control Rod See Figs. 5 And 6
View all Husqvarna 1830EXLT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
ASSEMBLY / PRE-OPERATION INSTALL TRACTION DRIVE CONTROL ROD (See Figs. 3 and 4) The traction drive control rod is installed on the snow thrower. 1. Remove plastic tie securing rod to lower handle. 2. With top end of rod positioned under left side of control panel, push rod down and insert top end of rod into hole in drive control bracket. Secure with retainer spring. PLASTIC TIE INSTALL AUGER CONTROL ROD (See Figs. 5 and 6) 1. Retrieve vinyl sleeve and spring from bag of parts and retrieve the auger control rod from carton chute tray. Slide straight rod end through the small hole in the vinyl sleeve. Using the long hook end of the spring, hook spring in hole #4 in rod. (See Fig. 5). 2. Hook end of spring into control arm with loop opening up as shown. (See Fig. 5). 3. With top end of rod positioned under right side of control panel, push down on rod and insert end of rod into hole in auger control bracket. Secure with retainer spring. TRACTION DRIVE CONTROL ROD VINYL SLEEVE CONTROL ARM VINYL SLEEVE AUGER CONTROL ROD FIG. 3 TRACTION DRIVE CONTROL LEVER RETAINER SPRING DRIVE CONTROL BRACKET FIG. 4 TRACTION DRIVE CONTROL ROD LOOP OPENING UP FIG. 5 AUGER CONTROL ROD RETAINER SPRING AUGER CONTROL LEVER AUGER CONTROL BRACKET FIG. 6 7