Husqvarna 120iTK4-P with battery and charger Owner Manual - Page 21
Troubleshooting
View all Husqvarna 120iTK4-P with battery and charger manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
4. Examine the groove in the guide bar for wear. Replace the guide bar if it is necessary. 7. Turn the guide bar daily to extend its life cycle. 5. Examine if the guide bar tip is rough or very worn. 6. Make sure that the bar tip sprocket turns freely and that the lubricating hole in the bar tip sprocket is not blocked. Clean and lubricate if it is necessary. To clean the product, the battery and the battery charger 1. Clean the product with a dry cloth after use. 2. Clean the battery and battery charger with a dry cloth. Keep the battery guide tracks clean. 3. Make sure that the terminals on the battery and the battery charger are clean before use. 4. Clean around the oil tank cap with a brush. 5. Clean the inner surface of the protective cover with a brush. To examine the battery and the battery charger 1. Examine the battery for damages, for example cracks. 2. Examine the battery charger for damages, for example cracks. 3. Make sure that the connection cord of the battery charger is not damaged and that there are no cracks in it. Troubleshooting Keypad Problem Possible faults Possible solution Green start LED flashes. Low battery voltage. Charge the battery. Red error LED flash- Overload. es. The cutting attachment is blocked. stop the product. Remove the battery. Clean the cutting attachment from unwanted materials. Loosen the chain. Temperature deviation. Let the product become cool. The power trigger and the start button are pushed at the same time. Release the power trigger and push the start button. The product does not Dirt in the battery connectors. start. Clean the battery connectors with compressed air or a soft brush. Red error LED comes on. It is necessary to do servicing on the product. Speak to your servicing dealer. 1636 - 004 - 03.12.2021 21