Hunter 30582 Owner's Manual - Page 12

Troubleshooting Problem 1. Unit does not operate. 2. Unusual noise; popping, sizzling, etc. 3. Pre-Filter and/or Main Filter indicator is on. 4. Unit has reduced air flow or increased noise. 5. Fault Indicator is on. Solutions • Confirm that the unit is plugged in. • Check the installation of the Pre-Filter, the Main Filter, and the Top Cover. (See pgs. 8, 9, & 10.) • Reset the Air Sterilizer. (See Resetting the Air Sterilizer, pg. 11.) • Check the installation of the Pre-Filter, the Main Filter, and the Top Cover. (See pgs. 8, 9, & 10.) • The Pre-Filter and/or Main Filter Life Counter has reached the estimated usage times. Check and clean the Pre-Filter and/or replace the Main Filter if needed. (See pgs. 7 - 10.) • The Pre-Filter and/or the Main Filter may be excessively dirty. Check and clean the Pre-Filter and/or replace the Main Filter if needed. (See pgs. 7 - 10.) • Check the installation of the Pre-Filter, the Main Filter, and the Top Cover. (See pgs. 8, 9, & 10.) • Reset the Air Sterilizer. (See Resetting the Air Sterilizer, pg. 11.) • If the Fault Indicator remains on after resetting the Air Sterilizer, turn the unit off and contact Hunter Technical Support. • The Pre-Filter and/or the Main Filter may be excessively dirty. Check and clean the Pre-Filter and/or replace the Main Filter if needed. (See pgs. 7 - 10.) Obtaining Replacement Main Filters To obtain replacement Main Filters for your Air Sterilizer, first determine your model number by looking at the information label on the back of the Air Sterilizer. The model number will be listed on the label. Then, call 1-800-4HUNTER for your nearest retailer or Hunter Customer Service at 1-888-830-1326 (CAN 1-866-268-1936). To ensure you obtain the correct filters, please find your model number below that specifies the correct replacement filters. Hunter Air Sterilizer Model No 30580, 30581, 30582 Replacement Main Filter No 30987 CADR 300 Recommended Room Size 21 x 22 43006-01 12