Honeywell 4800ISR051CE User Manual - Page 55

Presentation LED Behavior after Decode When an imager is in presentation mode, the LEDs remain on and continue scanning for a short time after a barcode is decoded. If you wish to turn the LEDs off immediately after a barcode is decoded, scan the LEDs Off barcode, below. Default = LEDs On. * LEDs On LEDs Off Presentation Sensitivity Presentation Sensitivity is a numeric range that increases or decreases the imager's reaction time to barcode presentation. To set the sensitivity, scan the Sensitivity barcode, then scan the degree of sensitivity (from 0-20) from the inside back cover, and Save. 0 is the most sensitive setting, and 20 is the least sensitive. Default = 1. Sensitivity Streaming Presentation™ Mode Note: Streaming Presentation Mode applies only to units with advanced illumination. Units with advanced illumination have a software revision of 31205480-118 or newer. Refer to the Show Software Revision on page 11-2 for information on determining the software in your unit. When in Streaming Presentation mode, the imager leaves the scan illumination on all the time and continuously searches for barcodes. Streaming Presentation Mode When using Preferred Symbology (page 3-14), a lower priority symbol must be centered on the aiming pattern to be read in Streaming Presentation Mode. 4600rp, 4600g/4600r, 4800i User's Guide 3 - 7