Hitachi CPS310W User Manual - Page 9

ENGLISH OPERATIONS Switching the Power Supply ON/OFF Switching Power ON 1. Check that the power cord is connected correctly. 2. Set the power switch to [ | ]. The standby mode is selected, and the Power indicator is turned to orange. 3. Press the STANDBY/ON button on the control panel or the remote control transmitter. Warm-up begins and the Power indicator blinks in green. 4. The Power indicator ceases blinking and turns to green when power is on. Open the slide lens door. 5. Adjust picture size using the projection lens Zoom Knob. 6. Adjust focus using the projection lens Focus Ring. POWER Indicator STANDBY/ON Button STANDBY/ ON Button STANDBY/ON VIDEO RGB MENU SELECT Zoom Knob MENU POSITION RESET Power Switch Slide Lens Door Focus Ring MAGNIFY FREEZE VOLUME MUTE OFF AUTO TIMER BLANK Switching Power OFF 1. Press the STANDBY/ON button on the control panel or the remote control transmitter for approximately two second. The projector lamp is extinguished and lamp cooling begins. The Power indicator blinks orange during lamp cooling. Pressing the STANDBY/ON button has no effect while the Power indicator is blinking. 2. The system assumes the Standby mode when cooling is complete, and the Power indicator ceases blinking and changes to orange. Check that the indicator is orange and set the Power switch to [O]. 3. The Power indicator is extinguished when power is off. Do not forget to close the lens door. WARNING Please read this manual, and the separate "SAFETY INSTRUCTIONS" thoroughly before using the equipment. Always ensure that the equipment is used safely. NOTE: • Except in emergencies, do not turn off unless the Power indicator is orange as it will reduce the life of the projector lamp. • To prevent any troble, turn on/off the projector when the computer or video tape recorder is OFF. Providing a RS-232C cable is connected, turn on the computer before the projector. ENGLISH-9