HP Vectra XE310 hp vectra xe310 series 1, service handbook chapter - Page 10

hp vectra xe310 Series 1 pc system board jumpers Jumper Function Default CLEAR Clears CMOS and passwords (to reload the Setup J6 program defaults) NORMAL Normal operation NORMAL DISABLE Clears User and Administrator passwords 1 J8 ENABLE Normal operation BIOS history ENABLE For the latest BIOS, the flasher utility program, and the BIOS history refer to the HP's Web site. http://www.hp.com/go/vectrasupport/ beep codes for hp vectra xe310 series 1 Beep Pattern Beep Code 1-2-2-3 1-3-1-1 1-3-1-3 1-3-3-1 Numeric Code 16h 20h 22h 1-3-4-1 2Ch 1-3-4-3 2Eh 1-3-4-3 30h -- - -- --- 2-1-2-3 46h 2-2-3-1 58h - -- 1-2 98h - 1 B4h Description BIOS ROM check-sum failure DRAM refresh test failure 8042 Keyboard controller test failure RAM module missing or not installed correctly1 RAM failure on address line xxxx2 RAM failure on data bits xxxx2 of low byte of memory bus RAM failure on data bits xxxx2 of high byte of memory bus ROM copyright notice check failure Unexpected interrupts test failure Video configuration failure or option ROMs check-sum failure This does not indicate an error. There is one short beep before system startup. 1. Non-HP memory modules are not supported. Only HP memory modules should be used. 2. If the BIOS detects error 2C or 2E (base 512K RAM error), it displays an additional word- bitmap (xxxx) indicating the address line or bits that failed. For example, "2C 0002" means address line 1 (bit one set) has failed. "2E 1020" means data bits 12 and 5 (bits 12 and 5 set) have failed in the lower 16 bits. 1-8 hp vectra xe310 Series 1 pc microtower vectras