HP T1500J HP UPS T1000 XR Models Extended Runtime Module Installation Instruct - Page 2

Kit Contents Documentation • Important Safety Information guide • International Regulatory Compliance guide • This document ERM • ERM chassis Cables • ERM power cable (attached to unit) Preparing for Installation Powering Down the UPS To power down the UPS: 1. Shut down all load devices. 2. Press the Standby button to take the UPS out of Operate mode. Power to the load receptacles ceases. 3. Disconnect the UPS from utility power. 4. Wait at least 60 seconds while the UPS internal circuitry discharges. Unpacking the ERM Carefully remove the kit contents from the shipping box following proper safety guidelines. Verify that all components are present. Completing the ERM Assembly Connecting the ERM to the UPS 1. Verify that the power to the UPS is off. 2. Plug the ERM cable into the connector located at the rear of the UPS in the lower left corner. NOTE: UPS appearance varies depending on the particular UPS ordered. Refer to the UPS user guide for the specific ERM connector location. 3. To install a second ERM, plug the cable from the second ERM into the socket at the rear of the first ERM. Charging the Batteries Allow the batteries to charge before putting the ERM into service. IMPORTANT: The battery pack charges to: • 90% of its capacity within 4 hours. • 100% of its capacity within 24 hours. Charge the batteries for at least 24 hours before using them to supply power to your devices. For more information, refer to the HP website at www.hp.com/products/ups