HP R1.5 UPS R12000 XR ERM Installation Instructions - Page 3
Tools and Materials Required, Unpacking the ERM, Mounting the Rails
View all HP R1.5 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
Tools and Materials Required The following tools are needed: • #3 Phillips screwdriver bit • Metric tools - 7 mm - 8 mm - 10 mm - 13 mm - 14 mm • Multimeter The following items are supplied with the HP rack: • Screws • Cage nuts • Cage nut-fitting tool Unpacking the ERM Transport the packaged ERM to its installation location. Unpack the ERM near the rack where it will be assembled. Follow the unpacking instructions on the carton. Verify that all components are present. WARNING: The battery modules are charged from the factory; do not touch the metal contacts inside the connector. Mounting the Rails The ERM must be mounted on the fixed rails supplied in this kit. To mount the rails: 1. Loosen the wing nuts (1) and extend the brackets (2) to the desired length. Tighten the wing nuts slightly to stabilize the bracket. 2 2. Use the rack template tool to measure and mark the screw locations for the rails on the front and rear of the rack. 3. Use the cage nut tool to install the cage nuts in the rear rack-mounting rails. 4. Insert at least one screw through each rack-mounting rail and into the front of each rail. 1