HP R/T3000 HP UPS R/T3000 G2 Installation Instructions - Page 3
Installing the UPS in a rack
![]() |
View all HP R/T3000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
2. Insert screws through the rack into the mounting rail and the front of each mounting bracket. 5. Tighten the wing nuts or hex nuts. 3. Install cage nuts or clip nuts into the rear of the rack. 6. Install the rear stabilization bracket using wing nuts. Wait until the unit is installed and the brackets are adjusted before tightening the nuts. 4. Insert screws through the mounting rail into the cage nuts or clip nuts. Installing the UPS in a rack Before installing the unit, review and adhere to all warnings provided in "Precautions (on page 1)." WARNING: A risk of personal injury or damage to the equipment exists. Uneven loading of equipment in the rack might cause the rack to become unstable. Install the heavier components first, and then continue to populate the rack from the bottom to the top. 1. Install the mounting rails ("Installing the mounting rails" on page 2). 2. Install the mounting ears on the chassis using the screws provided.
![](/manual_guide/products/hewlettpackard-rt3000-hp-ups-rt3000-g2-installation-instructions-2c3f2ed/3.png)