HP NetServer LT 6000r Installation Guide for Compaq Racks - Page 10
Control Panel
View all HP NetServer LT 6000r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Chapter 2 Overview Terms used in this document are defined in the table below. Term Bar nut Bezel Control Panel EIA unit Cage nut Rack (rack chassis, rack enclosure) Recessed mounting brackets Slide Slide mounting flange Definition Short, threaded bar used behind slide mounting flanges. Used in place of individual nuts to mate with slide mounting screws. Removable plastic fascia panel that covers entire front of the NetServer. This NetServer includes two bezels: one for installation in HP rack enclosures, and one for installation in Compaq 4000/7000 series rack enclosures. Display and buttons used to view NetServer status and change system parameters. Industry standard measurement (1.75 inches / 44.45 mm), consisting of three vertical mounting holes in a rack column. Single nut designed to clip into the rack column and accept a screw through the hole in the column. The equipment enclosure in which the NetServer will be installed. This document covers installation in a Compaq 4000/7000 series rack only. Two brackets (one tall, one short) that attach to the front of the NetServer and the front rack columns to hold the NetServer in the closed position. Extendible side bracket which is attached to the rack chassis columns on which the NetServer is mounted. Consists of stationary member, and an extendible member see Figure 3-3. Allows access to the NetServer after it is installed in the rack chassis. Mounting flange located at either end of the slide see Figure 3-3. 6