HP J9088A User Manual - Page 28
Removing the mini-GBICs, To remove the mini-GBICs that have the wire bail, lower the bail until it is - replacement
View all HP J9088A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
Installing the Switch Installation Procedures Removing the mini-GBICs Note You should disconnect the network cable from the mini-GBIC before removing it from the switch. Depending on when you purchased your ProCurve mini-GBIC, it may have either of three different release mechanisms: a plastic tab on the bottom of the mini-GBIC, a plastic collar around the mini-GBIC, or a wire bail. To remove the mini-GBICs that have the plastic tab or plastic collar, push the tab or collar toward the switch until you see the mini-GBIC release from the switch (you can see it move outward slightly), and then pull it from the slot. To remove the mini-GBICs that have the wire bail, lower the bail until it is approximately horizontal, and then using the bail, pull the mini-GBIC from the slot. Replace the protective plastic cover on the mini-GBIC. Installing the Switch 2-8