HP Indigo W7200 ITM Bearings Alignment - Page 26
Closing the ITM bearings cover screws,
View all HP Indigo W7200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
14. Install the rear and front caps, on the rear and front chucks, using 3 M4 screws that go into the ITM lamps holder threads. Figure 5-21 Installing the caps on rear and front chucks NOTE: Until this stage, the front and rear ITM bearing cover screws are supposed to be loose. Closing the ITM bearings cover screws Follow these steps to close the ITM bearings cover screws. 1. Attach Allen 5 mm bit to the torqueYou might also need to attach a moment lever due to the high torque closure. Figure 5-22 Setting the torque 24 Chapter 5 Aligning the ITM bearings
14.
Install the rear and front caps, on the rear and front chucks, using 3 M4 screws that go into the ITM
lamps holder threads.
Figure 5-21
Installing the caps on rear and front chucks
NOTE:
Until this stage, the front and rear ITM bearing cover screws are supposed to be loose.
Closing the ITM bearings cover screws
Follow these steps to close the ITM bearings cover screws.
1.
Attach Allen 5 mm bit to the torqueYou might also need to attach a moment lever due to the high torque
closure.
Figure 5-22
Setting the torque
24
Chapter 5
Aligning the ITM bearings