HP Desktop Pro A G3 MT Maintenance and Service Guide - Page 95
Interpreting system validation diagnostic front panel LEDs and audible codes
View all HP Desktop Pro A G3 MT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 95 highlights
Control panel message 904-SATA Cabling Error 90B-Fan Failure 90D-System Temperature 90E-Power Supply Fan Not detected 910-Filter Warning Description Recommended action One or more SATA devices are improperly attached. For optimal performance, the SATA 0 and SATA 1 ports should be used for hard drives before other ports. Ensure SATA connectors are used in ascending order. For one device, use SATA 0. For two devices, use SATA 0 and SATA 1. For three devices, use SATA 0, SATA 1, and SATA 2. The system has detected that a cooling fan is not operating correctly. 1. Reseat fan. 2. Reseat fan cable. 3. Replace fan. Thermal shutdown occurred. The system BIOS has detected your machine was previously shut down to avoid overheating. Overheating may occur if the cooling vents are blocked or the operating temperature exceeds the system specifications. The machine should return to normal operation once the situation is resolved. Make sure system has proper airflow. Power supply fan is not connected or may have 1. Reseat power supply fan. malfunctioned. 2. Reseat fan cable. 3. Replace power supply fan. Airflow filter is dirty. Replace the airflow filter. Interpreting system validation diagnostic front panel LEDs and audible codes During the system validation phase that occurs at system startup, the BIOS validates the functionality of the following subsystems and conditions: ● AC adapter ● System board power ● Processor failure ● BIOS corruption ● Memory failure ● Graphics failure ● System board failure ● BIOS authentication failure If an error is detected, specific patterns of long and short blinks, accompanied by long and short beeps (where applicable) are used to identify the error. These patterns will make up a two part code: ● Major - the category of the error ● Minor - the specific error within the category NOTE: Single beep/blink codes are not used. Number of long beeps/blinks 1 Error category Not used Interpreting system validation diagnostic front panel LEDs and audible codes 87