HP D5970A HP Netserver LXe Pro Installation Road Map - Page 4

5 Remove the Cover If you are installing options, you must remove the cover. These tools are required for cover removal and installation of accessories: ! A flat 1/4 inch screwdriver and T15 TORX® driver ! An antistatic service kit (3M® 8501/8502/8503 or equivalent). This kit includes a static-dissipating work surface, a chassic clip lead, and a wrist strap. WARNING Before removing the cover, always disconnect the power cord and unplug telephone cables. Disconnect the power cord to avoid exposure to high energy levels that can cause burns when metal objects such as tools or jewelry short-circuit component parts. Disconnect telephone cables to avoid exposure to shock hazard from ringing voltages. 1. Turn off the HP NetServer and disconnect the power cord. 2. Unlock the top cover using the keylock on the front control panel. 3. Loosen both top cover mounting screws on the back of the HP NetServer. 4. Slide the top cover back 0.5 inches (2 cm) and lift it straight up. CAUTION Wear a wrist strap and use a static-dissipating work surface connected to the chassis when handling components. Front Panel Key Lock 6 Install Additional Memory SIMM Installation Rules: ! use only 60 ns HP SIMMs listed on the Product Reference Label on the side of the HP NetServer chassis ! all SIMMs in a bank are identical in size ! two different SIMM sizes may be combined in the configurations shown at right below ! the selected configuration must match one of the Supported Memory Configurations shown NOTE If your system's product number ends in "A", go to Information Assistant to learn how to configure memory. Installation Instructions 1. Remove the Processing Cooling Duct Cover. 2. Determine the size of the SIMMs currently on the memory board and the size of the SIMMs to be added. Refer to the Supported Memory Configurations illustrations to choose the appropriate configuration. 3. Align the notch on the SIMM with the key in the socket. Key in Socket Retaining latch J16 J15 J14 J13 Bank 2 J12 J11 J10 J9 J8 J7 J6 J5 Bank 1 J4 J3 J2 J1 Notches 4. Insert the SIMM at a 70° angle into the socket and tilt the SIMM to 45° until the retaining clips snap into place. 70° 45° 5. Reinstall the board, fully seating it in the connector by closing the retaining latches and reinstalling the Processor Cooling Duct Cover. Verify that the board is properly aligned and seated before tightening the Processor Cooling Duct Cover screws. Processor Cooling Duct Cover Memory Board One SIMM size 4-SIMM Configuration 8-SIMM Configuration 16-SIMM Configuration Two SIMM sizes Choose two of the following SIMM sizes: 16, 32, 64 or 128 SIMM size #1 SIMM size #2 8-SIMM Configuration 16-SIMM Configuration